Archipelago » qemu

/*

 * ARM11MPCore internal peripheral emulation.

 *

 * Copyright (c) 2006-2007 CodeSourcery.

 * Written by Paul Brook

 *

 * This code is licensed under the GPL.

 */

#include "sysbus.h"

#include "qemu/timer.h"

/* MPCore private memory region.  */

typedef struct mpcore_priv_state {

    SysBusDevice busdev;

    uint32_t scu_control;

    int iomemtype;

    uint32_t old_timer_status[8];

    uint32_t num_cpu;

    MemoryRegion iomem;

    MemoryRegion container;

    DeviceState *mptimer;

    DeviceState *gic;

    uint32_t num_irq;

} mpcore_priv_state;

/* Per-CPU private memory mapped IO.  */

static uint64_t mpcore_scu_read(void *opaque, hwaddr offset,

                                unsigned size)

{

    mpcore_priv_state *s = (mpcore_priv_state *)opaque;

    int id;

    /* SCU */

    switch (offset) {

    case 0x00: /* Control.  */

        return s->scu_control;

    case 0x04: /* Configuration.  */

        id = ((1 << s->num_cpu) - 1) << 4;

        return id | (s->num_cpu - 1);

    case 0x08: /* CPU status.  */

        return 0;

    case 0x0c: /* Invalidate all.  */

        return 0;

    default:

        qemu_log_mask(LOG_GUEST_ERROR,

                      "mpcore_priv_read: Bad offset %x\n", (int)offset);

        return 0;

    }

}

static void mpcore_scu_write(void *opaque, hwaddr offset,

                             uint64_t value, unsigned size)

{

    mpcore_priv_state *s = (mpcore_priv_state *)opaque;

    /* SCU */

    switch (offset) {

    case 0: /* Control register.  */

        s->scu_control = value & 1;

        break;

    case 0x0c: /* Invalidate all.  */

        /* This is a no-op as cache is not emulated.  */

        break;

    default:

        qemu_log_mask(LOG_GUEST_ERROR,

                      "mpcore_priv_read: Bad offset %x\n", (int)offset);

    }

}

static const MemoryRegionOps mpcore_scu_ops = {

    .read = mpcore_scu_read,

    .write = mpcore_scu_write,

    .endianness = DEVICE_NATIVE_ENDIAN,

};

static void mpcore_priv_set_irq(void *opaque, int irq, int level)

{

    mpcore_priv_state *s = (mpcore_priv_state *)opaque;

    qemu_set_irq(qdev_get_gpio_in(s->gic, irq), level);

}

static void mpcore_priv_map_setup(mpcore_priv_state *s)

{

    int i;

    SysBusDevice *gicbusdev = sysbus_from_qdev(s->gic);

    SysBusDevice *busdev = sysbus_from_qdev(s->mptimer);

    memory_region_init(&s->container, "mpcode-priv-container", 0x2000);

    memory_region_init_io(&s->iomem, &mpcore_scu_ops, s, "mpcore-scu", 0x100);

    memory_region_add_subregion(&s->container, 0, &s->iomem);

    /* GIC CPU interfaces: "current CPU" at 0x100, then specific CPUs

     * at 0x200, 0x300...

     */

    for (i = 0; i < (s->num_cpu + 1); i++) {

        hwaddr offset = 0x100 + (i * 0x100);

        memory_region_add_subregion(&s->container, offset,

                                    sysbus_mmio_get_region(gicbusdev, i + 1));

    }

    /* Add the regions for timer and watchdog for "current CPU" and

     * for each specific CPU.

     */

    for (i = 0; i < (s->num_cpu + 1) * 2; i++) {

        /* Timers at 0x600, 0x700, ...; watchdogs at 0x620, 0x720, ... */

        hwaddr offset = 0x600 + (i >> 1) * 0x100 + (i & 1) * 0x20;

        memory_region_add_subregion(&s->container, offset,

                                    sysbus_mmio_get_region(busdev, i));

    }

    memory_region_add_subregion(&s->container, 0x1000,

                                sysbus_mmio_get_region(gicbusdev, 0));

    /* Wire up the interrupt from each watchdog and timer.

     * For each core the timer is PPI 29 and the watchdog PPI 30.

     */

    for (i = 0; i < s->num_cpu; i++) {

        int ppibase = (s->num_irq - 32) + i * 32;

        sysbus_connect_irq(busdev, i * 2,

                           qdev_get_gpio_in(s->gic, ppibase + 29));

        sysbus_connect_irq(busdev, i * 2 + 1,

                           qdev_get_gpio_in(s->gic, ppibase + 30));

    }

}

static int mpcore_priv_init(SysBusDevice *dev)

{

    mpcore_priv_state *s = FROM_SYSBUS(mpcore_priv_state, dev);

    s->gic = qdev_create(NULL, "arm_gic");

    qdev_prop_set_uint32(s->gic, "num-cpu", s->num_cpu);

    qdev_prop_set_uint32(s->gic, "num-irq", s->num_irq);

    /* Request the legacy 11MPCore GIC behaviour: */

    qdev_prop_set_uint32(s->gic, "revision", 0);

    qdev_init_nofail(s->gic);

    /* Pass through outbound IRQ lines from the GIC */

    sysbus_pass_irq(dev, sysbus_from_qdev(s->gic));

    /* Pass through inbound GPIO lines to the GIC */

    qdev_init_gpio_in(&s->busdev.qdev, mpcore_priv_set_irq, s->num_irq - 32);

    s->mptimer = qdev_create(NULL, "arm_mptimer");

    qdev_prop_set_uint32(s->mptimer, "num-cpu", s->num_cpu);

    qdev_init_nofail(s->mptimer);

    mpcore_priv_map_setup(s);

    sysbus_init_mmio(dev, &s->container);

    return 0;

}

/* Dummy PIC to route IRQ lines.  The baseboard has 4 independent IRQ

   controllers.  The output of these, plus some of the raw input lines

   are fed into a single SMP-aware interrupt controller on the CPU.  */

typedef struct {

    SysBusDevice busdev;

    SysBusDevice *priv;

    qemu_irq cpuic[32];

    qemu_irq rvic[4][64];

    uint32_t num_cpu;

} mpcore_rirq_state;

/* Map baseboard IRQs onto CPU IRQ lines.  */

static const int mpcore_irq_map[32] = {

    -1, -1, -1, -1,  1,  2, -1, -1,

    -1, -1,  6, -1,  4,  5, -1, -1,

    -1, 14, 15,  0,  7,  8, -1, -1,

    -1, -1, -1, -1,  9,  3, -1, -1,

};

static void mpcore_rirq_set_irq(void *opaque, int irq, int level)

{

    mpcore_rirq_state *s = (mpcore_rirq_state *)opaque;

    int i;

    for (i = 0; i < 4; i++) {

        qemu_set_irq(s->rvic[i][irq], level);

    }

    if (irq < 32) {

        irq = mpcore_irq_map[irq];

        if (irq >= 0) {

            qemu_set_irq(s->cpuic[irq], level);

        }

    }

}

static int realview_mpcore_init(SysBusDevice *dev)

{

    mpcore_rirq_state *s = FROM_SYSBUS(mpcore_rirq_state, dev);

    DeviceState *gic;

    DeviceState *priv;

    int n;

    int i;

    priv = qdev_create(NULL, "arm11mpcore_priv");

    qdev_prop_set_uint32(priv, "num-cpu", s->num_cpu);

    qdev_init_nofail(priv);

    s->priv = sysbus_from_qdev(priv);

    sysbus_pass_irq(dev, s->priv);

    for (i = 0; i < 32; i++) {

        s->cpuic[i] = qdev_get_gpio_in(priv, i);

    }

    /* ??? IRQ routing is hardcoded to "normal" mode.  */

    for (n = 0; n < 4; n++) {

        gic = sysbus_create_simple("realview_gic", 0x10040000 + n * 0x10000,

                                   s->cpuic[10 + n]);

        for (i = 0; i < 64; i++) {

            s->rvic[n][i] = qdev_get_gpio_in(gic, i);

        }

    }

    qdev_init_gpio_in(&dev->qdev, mpcore_rirq_set_irq, 64);

    sysbus_init_mmio(dev, sysbus_mmio_get_region(s->priv, 0));

    return 0;

}

static Property mpcore_rirq_properties[] = {

    DEFINE_PROP_UINT32("num-cpu", mpcore_rirq_state, num_cpu, 1),

    DEFINE_PROP_END_OF_LIST(),

};

static void mpcore_rirq_class_init(ObjectClass *klass, void *data)

{

    DeviceClass *dc = DEVICE_CLASS(klass);

    SysBusDeviceClass *k = SYS_BUS_DEVICE_CLASS(klass);

    k->init = realview_mpcore_init;

    dc->props = mpcore_rirq_properties;

}

static TypeInfo mpcore_rirq_info = {

    .name          = "realview_mpcore",

    .parent        = TYPE_SYS_BUS_DEVICE,

    .instance_size = sizeof(mpcore_rirq_state),

    .class_init    = mpcore_rirq_class_init,

};

static Property mpcore_priv_properties[] = {

    DEFINE_PROP_UINT32("num-cpu", mpcore_priv_state, num_cpu, 1),

    /* The ARM11 MPCORE TRM says the on-chip controller may have

     * anything from 0 to 224 external interrupt IRQ lines (with another

     * 32 internal). We default to 32+32, which is the number provided by

     * the ARM11 MPCore test chip in the Realview Versatile Express

     * coretile. Other boards may differ and should set this property

     * appropriately. Some Linux kernels may not boot if the hardware

     * has more IRQ lines than the kernel expects.

     */

    DEFINE_PROP_UINT32("num-irq", mpcore_priv_state, num_irq, 64),

    DEFINE_PROP_END_OF_LIST(),

};

static void mpcore_priv_class_init(ObjectClass *klass, void *data)

{

    DeviceClass *dc = DEVICE_CLASS(klass);

    SysBusDeviceClass *k = SYS_BUS_DEVICE_CLASS(klass);

    k->init = mpcore_priv_init;

    dc->props = mpcore_priv_properties;

}

static TypeInfo mpcore_priv_info = {

    .name          = "arm11mpcore_priv",

    .parent        = TYPE_SYS_BUS_DEVICE,

    .instance_size = sizeof(mpcore_priv_state),

    .class_init    = mpcore_priv_class_init,

};

static void arm11mpcore_register_types(void)

{

    type_register_static(&mpcore_rirq_info);

    type_register_static(&mpcore_priv_info);

}

type_init(arm11mpcore_register_types)