Add a Makefile target for profiling targets

[ganeti-local] / doc / walkthrough.rst

diff --git a/doc/walkthrough.rst b/doc/walkthrough.rst
index a173357..0719360 100644 (file)
--- a/doc/walkthrough.rst
+++ b/doc/walkthrough.rst
@@ -104,8 +104,8 @@ And let's check that we have a valid OS::
   debootstrap
   node1#
 
   debootstrap
   node1#
 

-Running a burnin
-----------------
+Running a burn-in
+-----------------

 
 Now that the cluster is created, it is time to check that the hardware
 works correctly, that the hypervisor can actually create instances,
 
 Now that the cluster is created, it is time to check that the hardware
 works correctly, that the hypervisor can actually create instances,

@@ -263,8 +263,8 @@ guide. Similar output lines are replaced with ``…`` in the below log::
       …
   node1#
 
       …
   node1#
 

-You can see in the above what operations the burnin does. Ideally, the
-burnin log would proceed successfully through all the steps and end
+You can see in the above what operations the burn-in does. Ideally, the
+burn-in log would proceed successfully through all the steps and end

 cleanly, without throwing errors.
 
 Instance operations
 cleanly, without throwing errors.
 
 Instance operations

@@ -584,7 +584,7 @@ reused. Re-adding it is simple::
   Mon Oct 26 05:27:39 2009  - INFO: Readding a node, the offline/drained flags were reset
   Mon Oct 26 05:27:39 2009  - INFO: Node will be a master candidate
 
   Mon Oct 26 05:27:39 2009  - INFO: Readding a node, the offline/drained flags were reset
   Mon Oct 26 05:27:39 2009  - INFO: Node will be a master candidate
 

-And is now working again::
+And it is now working again::

 
   node1# gnt-node list
   Node  DTotal DFree MTotal MNode MFree Pinst Sinst
 
   node1# gnt-node list
   Node  DTotal DFree MTotal MNode MFree Pinst Sinst

@@ -592,7 +592,7 @@ And is now working again::
   node2   1.3T  1.3T  32.0G  1.0G 30.4G     1     3
   node3   1.3T  1.3T  32.0G  1.0G 30.4G     0     0
 
   node2   1.3T  1.3T  32.0G  1.0G 30.4G     1     3
   node3   1.3T  1.3T  32.0G  1.0G 30.4G     0     0
 

-.. note:: If you have the Ganeti has been built with the htools
+.. note:: If Ganeti has been built with the htools

    component enabled, you can shuffle the instances around to have a
    better use of the nodes.
 
    component enabled, you can shuffle the instances around to have a
    better use of the nodes.